Content Attributes
Linksys WiFi extenders are the best devices to provide continuous internet range in those areas where your existing router fails to reach. After the Linksys WiFi extender setup, you will experience an uninterrupted internet range and coverage. Linksys WiFi extender lets you enjoy streaming movies or doing online tasks freely with a cup of tea under the sun.
But a few users report that they are unable to get the most out of their internet because of blinking LED on their Linksys device. Are you also one of those? If so, then this post would be helpful to you. Yes, here we have mentioned all the troubleshooting tips that will help you fix the blinking LED issue on your Linksys extender. Keep reading!
Reboot Your Extender
This is the most effective way to fix all Linksys extender-related problems. If you continuously see a blinking LED on your Linksys device, simply reboot it. To reboot your Linksys extender, apply the steps below in the exact given order:
- Unplug your Linksys extender.
- Disconnect it from your router (if connected).
- Wait for a few minutes.
- Plug your Linksys extender back in.
- Your Linksys device will blink for a few minutes and then become stable.
Hopefully, the aforementioned tip has helped you in fixing the issue. If the LED on your Linksys extender is blinking continuously, head toward the next tip.
Relocate Your Linksys Extender
If you have placed your Linksys extender out of the range of your main router, then also you might experience the blinking LED on your Linksys WiFi extender.
To fix the issue, make sure that your Linksys extender is placed in an area where it is receiving 30 percent of your router’s WiFi signals.
Apart from this, it is very much important to place your Linksys extender openly. So, if your Linksys extender is hidden behind an almirah or inside a box, place it openly on a higher shelf where it can spread the uninterrupted WiFi signals everywhere in your house.
Update the Extender’s Firmware
Still, seeing a blinking LED on your Linksys WiFi extender? If so, then make sure that the latest firmware on your Linksys extender is installed. The latest Linksys extender firmware update fixes issues like:
- Linksys range extender drops connection frequently.
- Blinking LED.
- Security and WiFi performance issues.
- Extender-router connectivity problems and so on.
To update the latest firmware on your Linksys device, navigate to extender.linksys.com via an internet browser. Once you are on the dashboard of your Linksys extender, follow the instructions and update your Linksys device’s firmware.
Reset Your Extender
This is the final remedy to fix the blinking LED on your Linksys extender. Resetting the Linksys extender back to the factory default settings will erase all data stored in it. So, we suggest, taking a backup of your extender’s settings. After resetting, you have to configure the Linksys extender again using the default values.
To reset Linksys extender:
- Disconnect it from your main router and other connected devices.
- Locate the Linksys extender reset hole.
- Hold the reset hole with a paper clip or pin for a few seconds.
- Release it.
- The Linksys extender power LED will blink for a few minutes and then become stable.
Your Linksys WiFi extender has been reset. Configure your Linksys extender’s settings again as per your WiFi requirements. Once the Linksys extender gets configured, you can connect your WiFi devices to the new extender’s WiFi network and enjoy the unbeatable internet range in every corner of your house.
We hope that this post has proven helpful to you in fixing the blinking LED issue on your Linksys WiFi range extender. If you are experiencing the same issue, without any hesitation, drop your queries into the comments section.